- sales@toponew.com
- +86 0512-65128852-801
Email format error
Email cannot be empty
Email already exists
6-20 characters(letters plus numbers only)
The password is inconsistent
Please enter the email address you’d like your password reset information sent to.
Email format error
Email cannot be empty
Email does not exist
Reset account password
For the account
6-20 characters(letters plus numbers only)
The password is inconsistent
Reset success
Your password was reset. You can log in using your new password.
Login
Offer Technical Support and Customized Solutions
The company is committed to creating new and improved plastic materials to meet the evolving demands of the market.
How to improve the toughness of transparent PP?
April 23,2024
Due to the relatively high rigidity of polypropylene molecular chains and a glass transition temperature around 0°C, how can the toughness of…
Read More
The Injection Molding Process of Polycarbonate (PC)
April 22,2024
PC, commonly known as polycarbonate, is colloquially referred to as bulletproof rubber due to its excellent mechanical properties. PC granules…
Read More
Global ABS Market Sales Set to Reach $38 Billion with 6% Annual Growth Rate
April 18,2024
The global ABS (Acrylonitrile Butadiene Styrene) market sales are projected to reach $38 billion by 2024, with a compound annual growth rate of 6.0%,…
Read More
Causes and Solutions for Defective Ejection in Injection Molded Products
April 17,2024
Adding fillers such as glass fibers and toughening agents to nylon can significantly enhance the mechanical properties of the material. However,…
Read More
Polyamide PA6 Injection Molding Process Conditions and Properties
April 16,2024
PA6 Polyamide 6 or Nylon 6？
Typical Applications: Due to its excellent mechanical strength and stiffness, it is widely used for structural…
Read More
Troubleshooting Surface Defects in TPE Injection-Molded Parts: Causes, Effects, and Solutions
April 15,2024
One of the reasons for surface issues in TPE injection-molded parts is the poor quality of raw materials TPE resin, as well as uneven dispersion of…
Read More
Why ABS Plastic Molded Products Crack
April 12,2024
The cracking issue of ABS resin molded products can be classified into the following three representative types based on visual inspection of the…
Read More
The Impact of Plastic Moisture Content on Injection Molded Parts
April 11,2024
The vaporization temperature of water is 100℃, and typically injection molding temperatures exceed 100℃. Water vaporizes at high temperatures,…
Read More
Addressing Shrinkage in Injection Molding: Strategies and Considerations
April 10,2024
Introduction: Shrinkage remains a persistent challenge in injection molding, often leading to defects and compromised product quality. In this…
Read More
The Future of Halogen-free Flame Retardant PA6, PA66
April 09,2024
In recent years, with the increasing global environmental awareness, halogen-free flame retardant materials have been receiving more and more…
Read More
Thermoplastic Elastomers: Causes of Testing Deviation and Shore A to Shore D Conversion
April 08,2024
Relative to other plastics, hardness is a more critical indicator for thermoplastic elastomers. Although hardness testing is relatively simple,…
Read More
Detailed Explanation of Nylon Injection Molding Process Adjustment
April 07,2024
Nylon is a widely used thermoplastic material, known for its excellent mechanical strength, wear resistance, and chemical resistance, making it widely…
Read More
Contact us
PRODUCT TAGS
Contact us
Please give your inquiry in the form below. We will reply you in 24 hours.